Time Clock Module Installation 3100/4100/5100
Click here to see this page in full context

Time Clock Module Installation 3100/4100/5100 Series

THIS PROCEDURE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.

WARNING

HAZARDOUS VOLTAGE: Risk of electric shock. Can cause injury or death. System may be connected to more than one branch circuit. Disconnect power to all circuits before servicing.

  1. De-energize the system and remove the electrical panel cover to gain access to the electrical panel.

  2. 4100/5100 Only: Insert plastic standoffs into the holes close to the base I/O board. If the heater does not have the holes for the standoffs, continue to step 3.

  3. Insert one end of the interface cable provided into the port on the time clock module.

  4. Insert the other end of the cable into the unused port on the relay expansion board.

  5. Tie wrap the time clock module to the existing wiring to hold the module in place or secure to the standoffs.

  6. Reinstall the electrical panel cover and restore power to the system. Configure the system with the peak control periods.

Links:

Document #1200358 Rev 14 02/02/2024