THIS PROCEDURE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.
If you have not done so already, please review the generic installation steps here.
THIS PROCEDURE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.
If you have not done so already, please review the generic installation steps here.
NOTE: One sensor per heater is required when connecting an outdoor sensor directly to the heater.
Disconnect power to the heater.
In the raceway at the back of the heater, connect the outdoor sensor wires to the gray wires in the low voltage wiring harness (figure 3 below).
Restore power to the heater.
Verify the configuration settings are correct and proper outdoor temperature is being received.
NOTE: Refer to Quantum Installation Instructions (1206036).
Low Voltage Diagram:
Low Voltage Raceway Cover:
1200119 Rev 12 06/14/2022