THIS PROCEDURE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.
If you have not done so already, please review the generic installation steps here.
NOTE: One sensor per heater is required when connecting an outdoor sensor directly to the heater.
-
Disconnect power to the heater.
-
In the raceway at the back of the heater, connect the outdoor sensor wires to the gray wires in the low voltage wiring harness (Figure 2).
-
Restore power to the heater.
-
Verify configuration settings are correct and proper outdoor temperature is being received (HELP Menu).
NOTE: Refer to Owner’s and Installer’s Manual for additional information.
Low Voltage Raceway Cover:
