Configuration Menu (Accessing) - 4200
Click here to see this page in full context

Configuration Menu - 4200 Series

IMPORTANT

If access to Configuration Menu times out, the 15 amp circuit breaker must be powered off and back on to re-enter the menu.

Serenity has a Configuration Menu that allows it to be customized to the power company and consumer’s needs. This menu can be accessed on start-up and allows configuration settings to be easily adjusted.

To access the Configuration Menu:

  1. Energize Serenity. Access to the Configuration Menu is allowed for the first two (2) minutes of operation. If Serenity has been energized for more than two (2) minutes, the 15 amp circuit breaker must be powered off and back on to gain access to this menu.
  2. Press and release the M button until faceplate displays "CONF".
  3. Press the up arrow once and the faceplate will display "C000". The faceplate will flash between "C000" and the corresponding configuration value.
  4. If necessary, edit the configuration value by pressing and holding the M button while using the up or the down arrow button to change the value.
  5. Once the value is correct, release the buttons and press the up arrow button to go to the next configuration (C001, C002, etc.)
  6. Repeat steps 4 through 5 until all configuration settings have been adjusted to the desired values.
  7. Once configured, use the down arrow to leave the Configuration Menu.

Links:

4200 Owner's Manual English 1201282 Rev 5