NOTE:The room heating unit is shipped from the factory preset with standard operating functions. Adjustments should not have to be made; however, if you find it is necessary to do so, this section contains the information for changing the standard configuration. Please proceed with caution when making the adjustments.
The data for the heater's operating functions are stored in specific locations in the heater's microprocessor and can be accessed through the control panel. All functions should be adjusted by the installer for the application at the time of the installation. The only adjustment the user should have to make is setting the room temperature which is typical with any heating system. If the ETS system has been set for manual charge control, the user will also need to adjust the brick core charge level on occasion.
Usually, the owner can access heater data stored in Locations 0 through 10 (L00 - L10) and can make adjustments if desired. When adjusting or viewing any of the heater data, the MODE digit will indicate an "L" or a "d".
L = Indicates the location of the heater function that is being viewed or changed. (See Figure 1.)
d = Indicates the specific data that is stored in a location. This data determines how the heater will function. (See Figure 2.)
