Low Voltage Terminal Strip |
||
---|---|---|
OS |
= |
Outdoor Sensor |
OS |
= |
Outdoor Sensor |
R |
= |
Low Voltage Hot |
P |
= |
Peak Control |
A |
= |
Anticipated Peak Control |
E |
= |
Room Temperature Set back |
C |
= |
Common |
OV1 |
= |
Override 1 |
OV2 |
= |
Override 2 |
OV3 |
= |
Override 4 |
OVC |
= |
Override Common |
OVR |
= |
Override Hot |
OVS |
= |
Override Switch |
NOTE: Each terminal accepts 22-16 AWG wire.
Remove applicable knockout(s), (1), from bottom of enclosure in low-voltage connection area.
Connect the peak control wires to R and P.
NOTE: Outdoor transceivers have a factory-installed outdoor temperature sensor (thermistor), (2). If the transmitter is being installed in an area where an accurate outdoor temperature is not available, the thermistor should be removed and an outdoor temperature sensor (Order Item #1302044) should be installed.
If installing an outdoor temperature sensor, connect the outdoor temperature sensor to the two OS terminals. The outdoor sensor must be placed in a location where it can accurately sense outdoor temperature and is not affected by direct sunlight or other abnormal temperature conditions.
NOTE: If necessary, the outdoor sensor can be extended to a total of 250 ft. No other loads can be controlled or supplied through this cable. It is for connection of the outdoor sensor ONLY.