DIP switches 2, 3, 4, and 5 are used to select the channel on which the receiver will receive. The receiver and the transmitting device MUST be set to the same channel for proper communication to occur. Select a channel and set DIP switches 2-5 according to the chart below:
|
Channel |
DIP Switch 2 |
DIP Switch 3 |
DIP Switch 4 |
DIP Switch 5 |
Channel Speed* |
Transmit Option *** |
|---|---|---|---|---|---|---|
|
1 |
ON |
OFF |
OFF |
OFF |
SLOW |
CONSTANT |
|
2 |
OFF |
ON |
OFF |
OFF |
SLOW |
INTERMITTENT |
|
3 |
ON |
ON |
OFF |
OFF |
FAST |
CONSTANT |
|
4 |
OFF |
OFF |
ON |
OFF |
FAST |
CONSTANT |
|
5 |
ON |
OFF |
ON |
OFF |
FAST |
CONSTANT |
|
6 |
OFF |
ON |
ON |
OFF |
FAST |
INTERMITTENT |
|
7 |
ON |
ON |
ON |
OFF |
FAST |
CONSTANT |
|
8 |
OFF |
OFF |
OFF |
ON |
FAST |
INTERMITTENT |
|
9 |
ON |
OFF |
OFF |
ON |
FAST |
CONSTANT |
|
10 |
OFF |
ON |
OFF |
ON |
FAST |
CONSTANT |
|
11 |
ON |
ON |
OFF |
ON |
FAST |
CONSTANT |
|
12 |
OFF |
OFF |
ON |
ON |
SLOW |
CONSTANT |
|
13 |
ON |
OFF |
ON |
ON |
SLOW |
CONSTANT |
|
14 |
OFF |
ON |
ON |
ON |
SLOW |
CONSTANT |
|
15 |
ON |
ON |
ON |
ON |
SLOW |
CONSTANT |
* Steffes 1000 and 2000 Series room heating units receive only on “slow” speed channels (Channels 1 or 2 as set from the factory or on channels 12/13 or 14/15 with a software upgrade). Slow channels transmit a signal every 3-4 minutes, so can take up to 7-10 minutes for a receiver to receive. Fast channels transmit every minute, so it generally only takes 2-3 minutes to receive.
** The Steffes transceiver transmits a signal over the power lines constantly unless set to one of the intermittent transmit channels shown above. If the power company’s control device is power line carrier (PLC) such as those manufactured by Cooper Power System/Cannon Technologies, the transceiver must transmit intermittently to allow the power company’s control device to operate properly. When set to transmit intermittently, the Steffes Heating systems will display a lower-than-normal percentage of good packets received.